ES Custom Construction provides drywall installation in Connecticut. Hung, taped, mudded, and sanded smooth. Three-coat work, no shortcuts on corner beads or screw pops. Walls ready to prime and paint. Licensed contractor, ten years on the tools.
Fully Licensed & Insured
Quality Work Since Day One
No-Cost Project Quotes
Proudly Serving Connecticut
Trusted & Verified
ES Custom Construction is a licensed drywall contractor in Connecticut. We provide professional drywall installation services on residential projects in Connecticut, including new construction drywall, remodel drywall hangs, repairs and patches, taping and mudding, skim coats, and ceiling drywall. Every sheet, screw, tape line, and finish coat gets handled by our crew.
Our drywall crew works in Fairfield County and the surrounding Connecticut area. We hang sheets tight to framing, screw to spec, embed tape in joint compound, run three coats, and sand smooth. Corner beads set straight, butt joints feathered wide, screw pops finished invisible. Connecticut walls get done right.
As a Connecticut drywall installer, we cover Danbury, Stamford, Norwalk, Greenwich, Fairfield, Westport, and the rest of the area. You hire Edwin and the crew direct. No tape and float crew showing up late, no rushed sanding, no waves visible after primer hits the wall.
Every drywall job we handle in Connecticut holds to the same standard: sheets fastened to schedule, joints embedded properly, three coats of mud, sanded to Level 4 or Level 5 finish on request. Connecticut homeowners hire us because drywall done wrong shows up the second the lights are on.
Drywall hung on new builds and additions. Sheets fastened to framing schedule, joints feathered wide, three-coat mud work sanded smooth and ready to prime.
Drywall hang on kitchen, bath, and basement remodels. We tie new sheets into existing walls and feather the joints invisible after primer goes on the surface.
Holes, cracks, water damage, and old patch jobs fixed properly. We cut out damaged sections, hang new drywall, tape, mud, sand, and finish to match.
Ceiling drywall hung level, screwed to schedule, taped and feathered wide. Butt joints sanded smooth so ceiling lights do not show the seams later.
Skim coats over textured walls, popcorn ceilings, or rough drywall. We scrape, prime, then trowel mud thin and sand smooth before the new paint coat.
Level 5 drywall finish on critical lighting conditions. Full skim coat over the entire surface, sanded flat. The wall reads smooth under raking light.
Tape embedded right, three coats of mud, sanded by hand. No waves, no bumps, no screw pops showing through the finish coat.
Butt joints feathered wide so they vanish after primer. Corner beads set plumb. Inside corners taped tight. Every seam disappears under paint.
Plastic on the floors, dust contained, drop cloths down. Sanding dust hauled out daily. The space stays clean from hang day through finish.
A single room runs three to five days, including hang, tape, three coats of mud, and sanding. Whole-house jobs take one to three weeks depending on square footage and finish level required.
Level 4 is the standard finish on most walls, fine under matte and eggshell paint. Level 5 is a full skim coat over the entire wall, needed when gloss paint or strong side lighting is in play.
Yes. We cut a clean square around the hole, screw a backer in, fit new drywall, tape, mud, and sand to blend with the existing wall. The patch reads invisible after paint.
Yes. We hang and finish ceiling drywall, including water-resistant board where needed. Ceilings get extra attention on the finish because raking light from windows shows every flaw.
Insulation goes between studs before drywall. Soundproofing usually means thicker drywall, sound channels, or double-layer assemblies. We can spec and install whatever the project needs.
Ready to start your next project? Contact ES Custom Construction today for a free consultation and personalized estimate.
